Recent content by Td66

They extended the vacuum hose rom 3.5 to 6 inches going to the crank case pressure sensor. this is the vacuum hose off to the right of the Y hose splitter. There is also a tune fix for this CEL.

The ducktail spoiler was purchased off of ebay pre painted, good price compared to other sites.

I have found a few things on Ebay lately...

Does this one interfere with the motion of the rear lockout? It does look super short.

Price is pretty high for a non dyno tune but I like what they are doing for the car. Plus they offer a DP midpipe combo to push that up closer to 80-90 hp

Well I did a few things recently, Often I forget to post some of those small changes.

The Eventuri was causing some code for other but never on mine, The recently discovered a 6.5 inch length vacuum hose dampened the signal to the crank case sensor. The air flows much louder on full throttle, and I believe its quicker in the low RPMs. Its by no means annoying as my Milltek is not...

One horn relay and then split from there.

Added a few things lately, some still in the mail, and one just arrived from Germany! I'll update as I install... 1. Spacers 2. Locking Lugs (Gorilla-all of them lock) 3. Eventuri CAI 4. Tint on Emblems 5. Blue Foot well LEDs 6. VLEDs blue license plate LEDs

No CEL as of now, It really does sound good and well the looks....

It mounts behind the OEM dash unit close to the back or side of the glove box. I used a thick piece of foam tape wrapped around the unit to avoid any squeaks. There is a small area to slide it up horizontally in that location. I believe it was 5 plug and play connectors and a ground. Here is a...

welcome!

Pre purchased this this morning as I have been anxiously awaiting the pre-order phase,.

Yes, it is intimidating. I had to drill one hole for the left side. The other uses the stock location.

yes to the left side behind fuse box